|
|
|
|
|
|
Work Around solution on Windows 2000 for problem where Vantage PCI board causes "New Hardware Found" dialog box to pop up everytime system boots up.
This assumes you have TAPI Express already installed. The procedure will show you how to uninstall the wave driver and then how to reinstall it using the "New Hardware Found" wizard while at the same time associating the wave driver with the newly found Vantage PCI device.
('location' below can also be winnt\system32, but you will need to copy OEMSETUP.INF to system32)
1. Click "cancel" on "New Hardware Found" dialog box
2. Go to My computer -> Manage -> Device Manager -> Sound, Video, Game controllers
3. Right click on "Brooktrout TAPI Express" and select "Uninstall"
note: If there's no separate Brooktrout entry right click on Legacy Audio Drivers and select Properties. In the next dialog select Properties again. Select Brooktrout TAPI Express and click Remove.
4. After finish Uninstallation, reboot your system
*** You will see New Hardware Found dialog box again when it boots up again ***
5. Click "Next" to add new hardware
6. In Find New Hardware select "Display List" option
7. Click "Next"
8. In Hardware Type select "Sound, Video, Game Controllers" from the list
9. Click "Next"
10. In Select a Device Driver just click "Have Disk"
11. Specify location of wave driver OEMSETUP.INF (default "c:\rht\wave\")
12. Click "OK"
*** Ignore "Digital Signature Not Found" by clicking "YES" ***
13. In Select a Device Driver now select "Brooktrout TAPI Express" from the list
14. Click "Next"
*** IF YOU SEE "UPDATE DRIVER WARNING" PLEASE IGNORE ***
15. In Start Hardware Installation click "Next"
*** Ignore "Digital Signature Not Found" by clicking "YES" ***
16. In Files Needed specify location of RHTWAVNT.DRV (default "c:\rht\wave\")
17. Click "OK"
18. Click OK on Brooktrout Wave Config Dialog
19. Click "Finish"
Installing the wave driver manually is done in a similar way by using the Add Hardware icon in the control panel. However to get rid of the New Hardware Found dialog use the above procedure.